First up is the M113
WFG20006 (1.72nd scale) US. Army M113 APC.
Resin kits can contain Airbubbles,
The hull is a one piece Polyurethane resin casting with the wheels and tracks cast in situ, the trim vane, hatches and rear ramp are all supplied as separate cast resin parts with the 0.50 cal mg supplied in white metal.
The blue spot on the side of the hull shows where a airbubble was filled in.
First go over the area with Sharpie (use a non permanent one) pen in this case Blue.
Then fill the airbubble with super glue and dust with either baking powder or talcum powder to set the super glue instantly.
Sand under water using the sanding sticks that I described how to make earlier on in the blog, use the pen marking as a guide.
When the pen mark have been sanded off the surrounding area the superglue has been sanded back to the surface of the model.
Prime the area to double check your work and if necessary do the process again.
WFG20003 Canadian Ram Badger Flame Thrower
WFG20004 US/British M4A1 Sherman Mid production.
WFG20016 M3 Grant Medium Tank (with desert side skirts)
That,s all for now folkes
No comments:
Post a Comment